To prevent the faulty operation either the blade size must be reduced to 6″ or the motor torque increased so that the cut can be made smoothly wo kicking which would require a 40 amp line and not be able to plug into a common wall outlet, as well as increasing the table size so as to leave ample room to place hands on the table at a safe distance from the blade.My next modification was for safety. I have no medical insurance, and I do not know where else to turn.īeing a product engineer myself the federal table saw injury lawsuit consolidation efforts do not go far enough, rather they missed the mark allowing fro these faulty products to continue being sold but with the addition of saw stop technology. I will never have more than 40% use of my hand. I have already had one surgery on my hand, and my Doctor has informed me I need more surgeries. I lost my ring finger on my left hand, and severed all the arteries in my left hand. I severed my hand in November 2008, 2008. I have written on the main page, and gave a brief description of my accident with a table saw. To have a potential DeWalt table saw lawsuit reviewed, request a free consultation and claim evaluation. If you, a friend or family member have suffered a severe laceration or other injury as a result of a defective DeWalt Jobsite Table Saw, you may be entitled to financial compensation. Individuals who own one of the recalled DeWalt table saws may contact the manufacturer at (888) 742-9178 to obtain the location of a service center where a free replacement saw can be obtained. The manufacturer indicates that if an “X” is stamped on the name plate by the date code, the table saw is not subject to the recall. The Saws are yellow and black, with the model number and date code located on a name plate on the front. The DEWALT jobsite table saw recall only applies to model number DW744 with date codes between 200740. This could cause a kick back, and poses a severe hazard of lacerations and serious injuries for users of the table saw.Īpproximately 13,000 of the defective table saws were sold throughout the United States between April 2007 and January 2008 for about $500 each. Defects could allow the pivot bracket on the saw to separate, leading to a misalignment of the blade and the fence. The table saws were manufactured by DeWalt Industrial Tool Company, based in Towson, Maryland.
Consumers have been told to immediately stop using the recalled saws, and individuals who were injured as a result of this defect may be entitled to compensation through a DeWalt Table Saw Lawsuit. The recall applies to the 10 inch DeWalt Jobsite Table Saw model number DW744. Consumer Product Safety Commission has announced a nationwide Dewalt Table Saw recall due to a defect which could lead to severe lacerations. Camp Lejeune Water Contamination Lawsuit.
0 kommentar(er)
